Septoria pressure builds ahead of T1

At the time of writing, most wheats in his region are around growth stage 30, with the more forward approaching GS 31. As day length and temperature increase, crops will race through growth stages, and every new leaf potentially creates a “ladder” for Septoria to climb if not controlled properly, Mr Marris warns.

“We need to prevent Septoria climbing that ladder by protecting new leaves as they emerge, using a good, strong fungicide, as well as dealing with any disease present on lower leaves. If we don’t, it’ll keep climbing the crop and hit the key leaves of leaf 2 and the flag leaf, which need to be kept as clean as possible.

“It’s also important to recognise that the majority of fungicides are protectant rather than curative, so we need to be proactive rather than reactive. Some products (e.g. Mefentrifluconazole) do offer an element of curativity, which gives flexibility if timings get stretched, but it’s not an approach we should be relying on.”

Where T0s have been delayed due to unsettled weather, Mr Marris says there may only be a very short period to the T1, and in such cases it is important sprays are still applied at the correct growth stage.

“As the weather warms up, leaf emergence can be rapid, so fungicide timing comes down to careful plant dissection to make sure you’re targeting the correct leaf, not relying on calendar date or the number of days since the last spray.”

Traditionally, T1s are applied around growth stage 32, however Farmacy’s head of integrated crop management, David Howard, says leaf three should be fully emerged before treating, which usually occurs between GS 31-33.

Two years ago, cool, dry conditions in April slowed crop growth, resulting in some T1s going on too early where growers focussed more on calendar date than crop development, he adds. This compromised coverage of leaf 3, and meant spray intervals to the flag leaf application were stretched, just as disease pressure surged following rain in April and May.

“Many older actives lack the curative ability they once did, so an adequate T1 is essential to avoid putting undue pressure on later applications by expecting them to control high levels of disease inoculum. This is particularly important for resistance management and protecting the future of key actives.”

Mr Howard says recent years have seen a gap develop in the potency of new chemistry, such as fenpicoxamid + prothioconazole, or fluxapyroxad + Mefentrifluconazole, over older SDHI/azole fungicides.

For curative Septoria control, he therefore favours newer chemistry, however SDHI/azole products, such as bixafen, Fluopyram + prothioconazole, have been effective in trials where timed well in protectant situations.

“The challenge is identifying whether situations are truly protectant or curative, especially if disease is still in the latent phase, so close inspection and assessment of all risk factors is fundamental.”

Looking ahead to T2, Mr Howard says Septoria will be the main focus, although yellow rust, and later-developing brown rust, should also be factored into programmes.

“The T2 protects the main two light-collecting leaves, responsible for 65-70% of total yield. A good product and robust dose is needed to protect crops through the backend of the season, when the bulk of yield building occurs.

“Curative action is needed too. Because the T1 is applied to leaf 3, it is unlikely to cover much of leaf 2 (unless applied very late), so leaf 2 could have been exposed to disease for some time. If disease pressure is high, with plenty of inoculum in crops, good curative action is essential – either from highly potent products, or higher doses of less potent products.”

Generally, the strongest curative options are either fluxapyroxad + Mefentrifluconazole, or fenpicoxamid + prothioconazole, so he says these will be go-to choices in anything other than a low risk situation. Both offer similar Septoria control, so deciding between the two may come down to other factors – e.g. Mefentrifluconazole is slightly better on brown rust, while fenpicoxamid has an edge against yellow rust.

Including the multisite folpet can be worthwhile for extending Septoria protection in high pressure situations, and for resistance management, he adds.

Of the older chemistry, AHDB fungicide performance work shows a notable drop in the efficacy of some SDHIs that were once the mainstay of T2 programmes, so growers need to be aware of the changes when choosing products, especially if curativity is needed.

“There is still a place for products based on actives such as bixafen, Fluopyram + prothioconazole, or other bixafen, Fluopyram mixtures, which have shown higher activity than other SDHIs in our trials. But if Septoria pressure becomes significant, higher rates will be required.”

If rust is the focus, rather than curative Septoria control, many products, such as benzovindiflupyr + prothioconazole, offer good efficacy and may deliver some Septoria protection too, he notes.

Ideally the T2 should be applied at GS 39, once flag leaves on main tillers are fully emerged, Mr Howard advises.

However, there can be big practical challenges to this, especially when treating large areas, and/or disease pressure is high, and varieties can differ quite significantly in the time taken for flag leaves to emerge.

“Crop stress, drilling date, nutrition, crop evenness, and other factors also affect flag leaf emergence, so all you can do is go for the majority, at a time when you can get around everything. Some may have to start spraying slightly earlier, say GS 37, but generally that’s better than being too late, letting disease take hold, and struggling to get curative control.”